The processing device of the piston rod includes a central frame, a tank card and a horizontal lathe, as well as a plurality of horizontal lathes set in the center, the central frame includes a pressure ring, claws and three independent claws are fixed at the end of the pressure ring and each claw The part is fastened with a pivot shaft and a screw clamp bearing. The bearing set in the tooling is on the central frame. The groove body has a cylindrical shape and has a clamping groove as a standard part, which can be installed on the outer wall of the piston rod.
Because of its simple structure and easy assembly, during processing, due to the vibration of the lathe, the parts will not move, the extraction device chip piston rod processing, it is provided with an inclined device under the processing part, the piston rod processing orifice plate , Due to the unloading of the application chip, there is a delay control switch, a delay control switch and the processing motor of the device, the control switch synchronizes the piston rod processing, which includes the opening of the upper side wall, the closed part of the closed wall of the tube wall, and the opening part is directly Located at the lower end of the orifice plate, and the length of this part of the opening is greater than the width of the orifice plate.
The collection box is located below the exit of the closed part, and has the advantages of simple structure and convenient chip extraction, greatly reducing the size of the chip, storage and convenient transportation time, and also improving the workshop environment. According to the modification process of the equipment, the hydraulic cylinder adopts laser coating Technical maintenance, learned about the coating process of the piston rod of the hydraulic cylinder, including the process parameters and the chemical composition of the deposited layer.
The flat structure piston rod processing is a process of cutting the piston rod of the hydraulic cylinder with less damage on the ground. The rod of the required length for cutting is rough. If the flat part of the piston rod is manufactured, and the forged flat part of the piston rod is square, so The manufactured piston rod is processed before processing to improve the hardness of the surface piston rod.